Camshaft Sprocket Bolt - 55 Ft. Lbs.
Camshaft Thrust Plate Bolts - 16 Ft. Lbs.
Coil Pack Bracket Bolts -190 In. Lbs.
Main Bearing Bolts Step 1 - 20 Ft. Lbs.
Main Bearing Bolts Step 2 - 85 Ft. Lbs.
Crankshaft Pulley Bolt - 230 Ft. Lbs.
Crankshaft Rear Seal Retainer Bolts - 16 Ft. Lbs.
Cylinder Head Bolts Step 1 - 43 Ft. Lbs.
Cylinder Head Bolts Step 2 - 105 Ft. Lbs.
Cylinder Head Cover Bolts - 144 In. Lbs.
Drive Plate to Crankshaft Bolts - 55 Ft. Lbs.
Drive Plate to Torque Converter Bolts - 35 Ft. Lbs.
EGR Tube Nut - 25 Ft. Lbs.
EGR Valve Bolts - 174 In. Lbs.
Engine Mount Through Bolt - 50 Ft. Lbs.
Engine Mount to Block Bolts - 35 Ft. Lbs.
Exhaust Manifold Bolts - 16 Ft. Lbs.
Generator Mounting Bolt - 30 Ft. Lbs.
Generator Bracket Bolts - 30 Ft. Lbs.
Heat Shield Nuts - 175 In. Lbs.
Hydraulic Tappet Yoke Retaining Bolts - 16 Ft. Lbs.
Intake Manifold Lower Bolts - 40 Ft. Lbs.
Intake Manifold Upper Bolts - 16 Ft. Lbs.
Oil Filter - 80 In. Lbs.
Oil Filter Connector - 34 Ft. Lbs.
Oil Pan 1/4-20 Bolts - 96 In. Lbs.
Oil Pan 5/16-18 Bolts - 144 In. Lbs.
Oil Pan Studs - 144 In Lbs.
Oil Drain Plug - 25 Ft. Lbs.
Oil Pickup Tube Bolts - 144 In. Lbs.
Oil Pump Bolts - 30 Ft. Lbs.
Oil Pump Cover - 125 In. Lbs.
Oil Pump Pressure Relief Plug - 15 Ft. Lbs.
Rocker Arm Bolts - 21 Ft. Lbs.
Spark Plugs - 30 Ft. Lbs.
Starter Bolts - 50 Ft. Lbs.
Timing Chain Cover Bolts - 35 Ft. Lbs.
Thermostat Housing Bolts - 220 In. Lbs.
Water Pump Bolts - 30 Ft. Lbs.
I have a 2002 magnum V 10, my back 2 bolts on the valve cover are leaking oil, change the gasket with Quality replacements and clean both surface and still seem to have seepage. Could I have a cracked valve cover? I have owned magnum, Vitense since 1995 and have never experienced this pesky valve cover leak if there is any advice, or if my suspicions are correct. please advise and help direct, thank you very much
V/R
tabellira442@gmail.com